Precautions for ceramic tile veneer to prevent detachment after decoration
Release time： 2018-05-31 09:33
In the decoration process, the veneer of the tile is crucial, once sloppy, although it can not be seen in the early days, but with the change of time, there will be problems such as falling off, so how to prevent the problem during the decoration?
Clean the base before putting up tiles
If there are decorative objects such as stone plaster, latex paint, wallpaper and so on on the wall, or there are dirt on the ground, it must be cleaned up, otherwise the cement mortar and the base is not firmly bonded; In addition, if the wall itself has cracks, it should be properly treated before it can be placed, so as not to cause the cracks of the basic structure to crack or fall off in the future; In addition, for the flatness or verticality gap is too large ground, wall, but also with cement mortar leveling treatment. Compare the color difference of the tile before laying.
The wall tiles should be well soaked
Because the wall tile has a high moisture content, this characteristic must be taken into account when pasting. The base should be fully watered and moistened before tiling, otherwise, the moisture in the mortar will be quickly absorbed and condensed by the dry base and tile, which will affect its bonding fastness. Otherwise, the wall tiles will absorb moisture from the cement, making the cement unable to act as a adhesive.
The floor tiles should be paved first
Lay the uncemented floor tile on the ground, knock flat, apply the cement slurry all over the floor tile, spread on the ground, the four bricks are flush diagonally. And the laying order is also exquisite. The floor tiles should be attached from the inside out. If the ground has slope or floor drain, it should be noted that the slope should be found in the direction of drainage. Wall tiles should be laid from bottom to top, for aesthetic reasons, the lowest layer of bricks should be pasted back. Press the floor tiles after finishing the wall tiles. In addition, a wall can not be attached to the top at a time to prevent the tile weight is large, causing collapse. Do not step on the floor tile for a short time.
Tile as many bubbles as possible
In summer, because the material is drier than usual, for floor tiles, tiles and other materials that need to be treated by soaking water, the time of soaking water treatment should be extended to make its moisture close to saturation. In this way, there will be no water absorption from the cement due to the drying of the tile during bonding, which will occur when the cement is not firmly bonded, and the phenomenon of empty drums and falling off will bring you some unnecessary trouble.
In order to cater to the pursuit of new consumers, there have been some new process methods on the market, such as ceramic tile adhesive, colorful caulk, seam paving and so on. Ceramic tile adhesive (also called dry paste method), ceramic tile does not need to be pre-soaked water base does not need to be wet, as long as the basic conditions of the pavement is good, so that the working condition is greatly improved.
Related news
Yangwei Industrial Zone, Cizao Town, Jinjiang City, Fujian Province
SAF Coolest v1.3.1.2 设置面板 NYNSX-ASFI-XASDE-ZZA
无数据提示
Sorry, The Current Column Is Being Updated, Please Stay Tuned!
You Can View Other Sections Or Go Back Home